MIL-DTL-24630 Valves, Check, In-Line, For Hydraulic Fluid And Lubricating Oil Fluid, General Specification ForThis specification covers the requirements for in-line check valves for use in hydraulic fluid and lubricating oil fluid systems of naval ships operating up to a maximum pressure of 3,000 pounds per square inch \(lb/in┬▓\).

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14

MIL-DTL-24630A(SH)

2.2.2 Other Government documents, drawings, and publications. The following other Government documents,

drawings, and publications form a part of this document to the extent specified herein. Unless otherwise specified,

the issues of these documents are those cited in the solicitation or contract.

NAVAL SEA SYSTEMS COMMAND (NAVSEA) PUBLICATIONS

S9074-AR-GIB-010/278

Requirements for Fabrication Welding and Inspection, and Casting

Inspection and Repair for Machinery, Piping, and Pressure Vessels

(Copies of this document are available online at https://nll.ahf.nmci.navy.mil, may be requested by phone at

215-697-2626, or may be requested by email at nllhelpdesk@navy.mil. This publication can be located by

searching the Navy Publications Index for the TMIN without the suffix.)

2.3 Non-Government publications. The following documents form a part of this document to the extent

specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or

contract.

ASME

ASME B46.1

Surface Texture (Surface Roughness, Waviness and Lay)

(Copies of this document are available online at www.asme.org.)

ASTM INTERNATIONAL

ASTM A582/A582M

Standard Specification for Free-Machining Stainless Steel Bars

ASTM B369

Standard Specification for Copper-Nickel Alloy Castings

(Copies of these documents are available online at www.astm.org.)

NATIONAL FLUID POWER ASSOCIATION (NFPA)

Fluid Power Components � Method for Verifying the Fatigue and Establishing the

NFPA-T2.6.1

Burst Pressure Ratings of the Pressure Containing Envelope of a Metal Fluid Power

Component

(Copies of this document are available online at www.nfpa.com.)

SAE INTERNATIONAL

SAE-AMS7276

Rubber: Fluorocarbon (FKM) High-Temperature-Fluid Resistant Low

Compression Set for Seals in Fuel systems and Specific Engine Oil

Systems

SAE-AMS-QQ-S-763

Steel, Corrosion Resistant, Bars, Wire, Shapes, and Forgings

SAE-AS598

Aerospace Microscopic Sizing and Counting of Particulate Contamination

for Fluid Power Systems

SAE-AS4059

Aerospace Fluid Power - Cleanliness Classification for Hydraulic Fluids

SAE-AS4716

Gland Design, O-ring and Other Elastomeric Seals

SAE-AS5781

Retainers (Backup Rings), Hydraulic and Pneumatic,

Polytetrafluoroethylene Resin, Single Turn, Scarf-Cut, for Use in AS4716

Glands