INCH-POUND
MIL-DTL-24630A(SH)
17 June 2014
SUPERSEDING
MIL-V-24630(SH)
19 March 1984
DETAIL SPECIFICATION
VALVES, CHECK, IN-LINE, FOR HYDRAULIC FLUID AND LUBRICATING OIL FLUID, GENERAL
SPECIFICATION FOR
This specification is approved for use by the Naval Sea Systems Command, Department of the Navy, and is
available for use by all Departments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the requirements for in-line check valves for use in hydraulic fluid and
lubricating oil fluid systems of naval ships operating up to a maximum pressure of 3,000 pounds per square
inch (lb/in²).
1.2 Classification. In-line check valve assemblies are designated by standard part numbers as follows (see 1.3)
and as specified (see 6.2).
1.3 Part or identifying number (PIN).
M
24630
/1
-
XX
Prefix for Military
Specification
Applicable
-
Dash number to represent
Specification
Number
specification
dimension and flow
sheet number
requirement (see specification
sheet for dash numbers)
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples. While every effort has been made to ensure the completeness of this list, document
users are cautioned that they must meet all specified requirements of documents cited in sections 3 and 4 of this
specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
those cited in the solicitation or contract.
FEDERAL SPECIFICATIONS
QQ-N-281
-
Nickel-Copper Alloy Bar, Rod, Plate, Sheet, Strip, Wire, Forgings, and Structural
and Special Shaped Sections
Comments, suggestions, or questions on this document should be addressed to: Commander, Naval Sea Systems
Command, ATTN: SEA 05S, 1333 Isaac Hull Avenue, SE, Stop 5160, Washington Navy Yard DC 20376-5160 or
emailed to CommandStandards@navy.mil, with the subject line "Document Comment". Since contact information
can change, you may want to verify the currency of this address information using the ASSIST Online database at
https://assist.dla.mil.
AMSC N/A
FSC 4820
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business