MIL-PRF-6164G
SAE-AMS2610
-
Pressure Testing, Gaseous Media Pressure as Specified
SAE-AS5202
-
Port or Fitting End, Internal Straight Thread (DoD adopted)
Screw Threads UNJ Profile, Inch Controlled Radius
SAE-AS8879
-
Root with Increased Minor Diameter
SAE-AMS-P-83461/1 -
Packing, Preformed, Petroleum Hydraulic Fluid Resistant,
Improved Performance at 275oF (135oC) Sizes and
Tolerances (DoD adopted)
SAE-AMS-R-83485/1-
Rubber, Fluorocarbon Elastomer, Improved Performance
at Low Temperatures, O-Rings, Sizes and Tolerances
(DoD adopted)
(SAE documents may be obtained at https://www.sae.org/ or addressed to Society of Automotive
Engineering, Inc., 400 Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict
between the text of this document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless
a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection
in accordance with 4.2.
3.2 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible, provided
that the material meets or exceeds the operational and maintenance requirements, and promotes
economically advantageous life cycle costs.
3.3 Materials. All materials shall be corrosion resistant or treated to resist corrosion due to
electrolytic decomposition, salt air, and any other atmospheric condition that may be encountered
during operational use or storage. The use of toxic chemicals, hazardous substances, or ozone
depleting chemicals shall be avoided, whenever feasible.
3.4 Interface.
3.4.1 Dimensions. The dimensions of the M6164-2 through M6164-5 and M6164-12 valves
shall conform to figure 1.
3.4.2 Bosses. The M6164-2 through M6164-5 valves shall install into SAE-AS5202 or
MS33651 boss. The M6164-12 valve shall install into a boss (see MS33651 for guidance), but
the selected boss must be rated for a maximum pressure of 8,000 psig.
3.5 Performance.
3.5.1 Cap. The valve shall have a cap in accordance with MS20813.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business